UV-Fenton氧化预处理聚醚废水研究

采用UV-Fenton氧化法对聚醚废水预处理,通过正交和单因素试验探讨了H2O2投加量、Fe2+投加量、p H值及光照时间各因素对废水COD去除率的影响,确定p H值为3、H2O2投加量40 m L/L、n(H2O2)/n(Fe2+)=9、光照时间90 min为最佳反应条件,COD去除率可达70%以上,经氧化预处理后废水的BOD/COD值由0.19提至0.37,可生化性较大提高,可满足后续生化处理的要求。     

化学沉淀组合电催化氧化处理脱硫废液技术研究

真空碳酸钾脱硫工艺碱洗段废液因含有高浓度硫化物、COD等有毒成分而影响焦化废水后续生物处理。以焦化企业实际碱洗段废液为研究对象,选用化学沉淀和电催化氧化的组合方式对其进行预处理。结果表明,室温下当氧化铜的投加量为65 g/L、反应时间60 min时废液中S2-去除率可达93%,且经过高温灼烧可实现Cu O沉淀剂的再生使用。沉淀后出水经电催化氧化处理,在电流10 A、电压4.9 V、电解时间120 min的条件下,出水COD可降至2 400 mg/L,满足常规生化系统进水的要求。     

改性活性炭纤维吸附炸药废水中TNT实验研究

本文研究了改性活性炭纤维对炸药废水中TNT的吸附行为。研究表明:1 mol/L HNO3改性的活性炭纤维吸附效果最好,其对炸药废水中TNT的最佳吸附条件为:吸附剂用量为0.6 g/25 m L,吸附平衡时间为60 min,升温有利于吸附进行。Langmuir和Freundlich吸附等温线均能较好地描述活性炭纤维对TNT的吸附,吸附动力学分析表明,吸附过程遵循准二级动力学规律。     

IC反应器处理制浆洗草废水的内循环状况

中试用内循环厌氧反应器处理制浆造纸厂的洗草废水,并探讨内循环系统的循环状况。试验表明,洗草水不适合进行深度厌氧处理,宜进行水解酸化。由于洗草废水的有机物浓度低,产气量小,反应器内循环系统仅产生了不连续的提升,液体提升量与产气量的比值在0.08~0.36,下降管中产生了间歇性回流,液体的流量达到了518.4~725.1 L/h。     

油田井场废水配制压裂液处理技术实验研究

针对油田井场废水高悬浮物、高色度、高金属离子浓度的特征,以处理后配制压裂液为目标,通过p H值调节及无机高分子絮凝法对井场废水进行了处理实验。结果表明,碳酸钠作为优选的p H值调节剂,可以在较低的p H值条件下有效去除废水中的高价金属离子;无机絮凝剂聚合硫酸铁在强碱性条件下对于悬浮物、色度的去除效果明显优于聚合氯化铝。聚合硫酸铁絮凝法可以使井场废水达到配制压裂液用水的要求。     

饮用水中氧化性物质的危害及处理技术研究进展

氧化性物质作为饮用水中一种特殊污染物已对人体健康产生了危害,如何有效地去除这些物质迫在眉睫。对水中氧化性物质的产生、危害及其处理技术进行总结,详述了物化处理和氢自养生物还原处理技术的原理、特点及国内外的研究进展。     

微波-混凝处理高炉煤气洗涤水的实验研究

本文探索了微波作为辅助手段处理高炉煤气洗涤水过程中,微波辐射功率、微波辐射时间、聚合氯化铝(PAC)加入量、磷酸加入量对高炉煤气洗涤废水处理效果的影响。结果表明,微波和PAC混凝联用处理高炉煤气洗涤废水具有作用时间短、聚沉能力强等特点,可以有效去除废水中悬浮物,降低硬度及浊度。     

污泥热化学处理研究进展

由于传统污泥处置技术存在局限性,污泥热化学处理技术更具有应用前景。综述了近几年国内外污泥热化学处理技术的研究进展,在此基础上介绍了污泥热解、污泥气化及污泥超临界水气化3种污泥处理技术,归纳了温度、升温速率、催化剂等因素对3种污泥热化学处理技术污泥处置后产物特性、尤其是富氢气体产物的影响规律,简明阐述了不同污泥热化学处理方式的特点,对比了3种热化学处理方法的差异。还介绍了污泥热解、气化技术的工业实例和一般工艺流程,分析了不同处置技术存在的问题,对今后污泥高效利用提出了建议。     

Effects of water regime,crop residues,and application rates on control of Fusarium oxysporum f. sp. cubense

Biological soil disinfestation is an effective method to control soil-borne disease by flooding and incorporating with organic amendments, but field conditions and resources sometimes limited its practical application. A laboratory experiment was conducted to develop practice guidelines on controlling Fusarium wilt, a widespread banana disease caused by Fusarium oxysporum f. sp. cubense (FOC). FOC infested soil incorporated with rice or maize straw at rates of 1.5 tons/ha and 3.0 tons/ha was incubated under flooded or water-saturated (100% water holding capacity) conditions at 30°C for 30 days. Results showed that FOC populations in the soils incorporated with either rice or maize straw rapidly reduced more than 90% in the first 15 days and then fluctuated till the end of incubation, while flooding alone without organic amendment reduced FOC populations slightly. The rapid and dramatic decrease of redox potential (down to − 350 mV) in straw-amended treatments implied that both anaerobic condition and strongly reductive soil condition would contribute to pathogen inactivation. Water-saturation combined with straw amendments had the comparable effects on reduction of FOC, indicating that flooding was not indispensable for inactivating FOC. There was no significant difference in the reduction of FOC observed in the straw amendments at between 1.5 and 3 tons/ha. Therefore, incorporating soil with straw (rice or maize straw) at a rate of 3.0 tons/ha under 100% water holding capacity or 1.5 tons/ha under flooding, would effectively alleviate banana Fusarium wilt caused by FOC after 15-day treating under 30°C.     

San copolymer membranes with ion exchangers for Cu(II) removal from synthetic wastewater by electrodialysis

Heterogeneous membranes were obtained by using styrene-acrylonitrile copolymer (SAN) blends with low content of ion-exchanger particles (5 wt.%). The membranes obtained by phase inversion were used for the removal of copper ions from synthetic wastewater solutions by electrodialytic separation. The electrodialysis was conducted in a three cell unit, without electrolyte recirculation. The process, under potentiostatic or galvanostatic control, was followed by pH and conductivity measurements in the solution. The electrodialytic performance, evaluated in terms of extraction removal degree (rd) of copper ions, was better under potentiostatic control then by the galvanostatic one and the highest (over 70%) was attained at 8 V. The membrane efficiency at small ion-exchanger load was explained by the migration of resin particles toward the pores surface during the phase inversion. The prepared membranes were characterized by various techniques i.e. optical microscopy, Fourier transform infrared spectroscopy, scanning electron microscopy, thermogravimetric analysis and differential thermal analysis and contact angle measurements.